Cisco Nexus 3600 NX-OS - Configuring ACL TCAM Region Sizes

PurposeCommand
Displays the IPv6 ACL configuration.switch# show ipv6 access-lists
Displays information on the active logged flows, such
as source IP and destination IP addresses, source port
and destination port information, and source
interfaces.
switch# show logging ip access-list cache [detail]
Displays the deny maximum flow count, the current
effective log interval, and the current effective
threshold value..
switch# show logging ip access-list status
Displays the access control list (ACL) log file in the
startup configuration.
switch# show startup-config acllog
Displays the access control list (ACL) log file in the
startup configuration.
This command displays the user-configured
ACLs in the startup configuration. The all
option displays both the default
(CoPP-configured) and the user-configured
ACLs in the startup configuration.
Note
switch# show startup-config aclmgr [all]
Displays the access control list (ACL) log file in the
running configuration.
switch# show running-config acllog
Displays the access control list (ACL) log file in the
running configuration including the IP ACL
configuration and the interfaces where you have
applied IP ACLs.
This command displays the user-configured
ACLs in the running configuration. The all
option displays both the default
(CoPP-configured) and the user-configured
ACLs in the startup configuration.
Note
switch# show running-config aclmgr [all]
Configuring ACL TCAM Region Sizes
You can change the size of the ACL ternary content addressable memory (TCAM) regions in the hardware.
You cannot change the size of the small TCAMs (TCAM 12 through 15)Note
Cisco Nexus 3600 NX-OS Security Configuration Guide, Release 7.x
95
Configuring IP ACLs
Configuring ACL TCAM Region Sizes