Cisco Nexus 5500 Series - Manually Setting the Device Clock; Setting the Clock Manager

Manually Setting the Device Clock
You can set the clock manually if your device cannot access a remote time source.
Before You Begin
Configure the time zone.
SUMMARY STEPS
1.
clock set time day month year
2.
(Optional) show clock
DETAILED STEPS
PurposeCommand or Action
Configures the device clock.
clock set time day month year
Step 1
Example:
switch# clock set 15:00:00 30 May 2008
Fri May 30 15:14:00 PDT 2008
The format for the time argument is hh:mm:ss.
The range for the day argument is from 1 to 31.
The values for the month argument are January, February, March,
April, May, June, July, August, September, October, November,
and December.
The range for the year argument is from 2000 to 2030.
(Optional)
Displays the current clock value.
show clock
Example:
switch(config)# show clock
Step 2
Related Topics
Configuring the Time Zone, on page 98
Setting the Clock Manager
You can configure the clock manager to synchronize all the clocks of the components in the Cisco Nexus
chassis.
SUMMARY STEPS
1.
clock protocol protocol vdc vdc-num
2.
(Optional) show run clock_manager
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
OL-30890-01 101
Basic Device Management
Manually Setting the Device Clock