Cisco Nexus 5500 Series - Sending a Message to Users; Verifying the Device Configuration

DETAILED STEPS
PurposeCommand or Action
Displays the user sessions.show users
Example:
switch# show users
Step 1
Sending a Message to Users
You can send a message to active users currently using the device CLI.
SUMMARY STEPS
1.
(Optional) show users
2.
send [session line] message-text
DETAILED STEPS
PurposeCommand or Action
(Optional)
Displays the active user sessions.
show users
Example:
switch# show users
Step 1
Sends a message to all active users or to a specific user. The
message can be up to 80 alphanumeric characters and is case
sensitive.
send [session line] message-text
Example:
switch# send Reloading the device is 10
minutes!
Step 2
Verifying the Device Configuration
To verify the configuration after bootstrapping the device using POAP, use one of the following commands:
PurposeCommand
Displays the running configuration.show running-config
Displays the startup configuration.show startup-config
Cisco Nexus 5500 Series NX-OS Fundamentals Configuration Guide, Release 7.x
OL-30890-01 103
Basic Device Management
Sending a Message to Users