Service:
Version: 6.1(2)I1(1)
2) At 791071 usecs after Wed Jun 26 20:04:50 2013
Reason: Reset Requested by CLI command reload
Service:
Version: 6.1(2)I1(1)
3) At 70980 usecs after Wed Jun 26 19:55:52 2013
Reason: Reset Requested by CLI command reload
Service:
Version: 6.1(2)I1(1)
4) At 891463 usecs after Wed Jun 26 23:44:48 2013
Reason: Reset Requested by CLI command reload
Service:
Version: 6.1(2)I1(1)
Standby Supervisor Fails to Boot
The standby supervisor does not boot after an upgrade. You may see the following system message:
SYSMGR-2-STANDBY_BOOT_FAILED
This message is printed if the standby supervisor does not complete its boot procedure (does not reach the
login prompt on the local console) 3 to 6 minutes after the loader has been loaded by the BIOS. This message
is usually caused by boot variables not properly set for the standby supervisor. This message can also be
caused by a user intentionally interrupting the boot procedure at the loader prompt (by pressing ESC).
Connect to the local console of the standby supervisor. If the supervisor is at the loader prompt, try to use the
boot command to continue the boot procedure. Otherwise, enter the reload command for the standby supervisor
from a vsh session on the active supervisor, specifying the force-dnld option. Once the standby is online, fix
the problem by setting the boot variables appropriately.
SolutionPossible CauseSymptom
Reload the active supervisor from
bootflash:.
Active supervisor nx-os image booted
from TFTP.
Standby supervisor
does not boot.
Recovering the Administrator Password
You can recover the network administrator password using one of these methods:
•
From the CLI with a username that has network-admin privileges
•
By power cycling the device
•
By reloading the device
Cisco Nexus 9000 Series NX-OS Troubleshooting Guide, Release 7.x
24
Troubleshooting Installations, Upgrades, and Reboots
Standby Supervisor Fails to Boot
To Next Page
Loading...
