Cisco Nexus 9000 Series - Troubleshooting Policy-Based Routing

Troubleshooting Policy-Based Routing
•
Make sure the ACLs match the incoming traffic.
•
Make sure the route is available:
◦
For IP network routes, use the show ip route command to make sure the IP network route is
available for the next hop specified in the set ip next-hop command.
◦
For IP host routes, use the show ip arp command to make sure the IP host route is available for
the next hop specified in the set ip next-hop command.
◦
For IPv6 network routes, use the show ipv6 route command to make sure the IPv6 network route
is available for the next hop specified in the set ipv6 next-hop command.
◦
For IPv6 host routes, use the show ipv6 neighbor command to make sure the IPv6 host route is
available for the next hop specified in the set ipv6 next-hop command.
•
Make sure the policy is active in the system (using the show ip policy command).
•
Check the statistics for the entry (using the show route-map map-name pbr-statistics command).
Cisco Nexus 9000 Series NX-OS Troubleshooting Guide, Release 7.x
67
Troubleshooting Routing
Troubleshooting Policy-Based Routing