Cisco Nexus 9000 Series - Page 43

DETAILED STEPS
PurposeCommand or Action
—
Establish a terminal session on the console port of the active supervisor module.
Step 1
Reloads the device to reach the loader
prompt. You need to press Ctrl-C when
the following appears:
Booting nx-os image:
bootflash:/n9000-dk9.x.x.x.bin....
switch# reload
Example:
switch# reload
This command will reboot the system. (y/n)? [n] Y
2013 Jun 7 13:09:56 switch %$ VDC-1 %$
Step 2
%PLATFORM-2-PFM_SYSTEM_RESET:
Manual system restart from Command Line Interface
writing reset reason 9,
..
..
GNU GRUB version 0.97
Autobooting bootflash:/n9000-dk9.x.x.x.bin bootflash:/n...
Filesystem type is ext2fs, partition type 0x83
Booting nx-os image: bootflash:/n9000-dk9.x.x.x.bin....(---->
Press Ctrl + C)
....Aborting Image Boot
GNU GRUB version 0.97
Loader Version 3.22.0
loader>
Restarts the device with only the nx-os
image to reach the switch boot prompt.
loader> boot n9000-dk9.x.x.x.bin
Example:
loader> boot n9000-dk9.x.x.x.bin
Filesystem type is ext2fs, partition type 0x83
Step 3
Booting nx-os image: n9000-dk9.6.1.2.I1.1.gbin....
................................................
.....................Image verification OK
..
..
Lesser General Public License (LGPL) Version 2.1.
A copy of each such license is available at
http://www.opensource.org/licenses/gpl-2.0.php and
http://www.opensource.org/licenses/lgpl-2.1.php
switch(boot)#
—
Reset the network administrator password by following Steps 6 through 20 in
Power Cycling the Device to Recover the Administrator Password, on page
25.
Step 4
Cisco Nexus 9000 Series NX-OS Troubleshooting Guide, Release 7.x
31
Troubleshooting Installations, Upgrades, and Reboots
Recovering the Administrator Password