CHAPTER 1
Overview
• Overview, on page 1
Overview
This switch chassis includes the following modules:
• Supervisor modules (one or two)—one of the following types in slots SUP 1 and SUP 2 (Modules 27
and 28 in reports) (numbered from left to right on the chassis)
• System controllers (two) (N9K-SC-A) in slots SC 1 and SC 2 (numbered from left to right on the chassis)
• Line cards (up to four) in slots LC 1 to LC 4 (numbered from top to bottom on the chassis) supported
by the same type of fabric module
For compatibility information, please refer to the Line Card and Fabric Module Compatibility data sheets.
Do not mix ACI-mode line cards with NX-OS mode line cards in the same
switch.
Note
• Fabric modules in slots FM 1 to FM 6 (numbered from left to right on the chassis)
See the following table for the required fabric module types and quantities required for maximum
bandwidth.
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
1
To Next Page
Loading...
