CHAPTER 5
Managing the Switch
• Displaying Information About the Installed Hardware Modules, on page 45
• Displaying the Hardware Inventory for a Switch, on page 49
• Displaying Fabric Utilization Information, on page 49
• Displaying the Backplane and Serial Number Information, on page 52
• Displaying Environmental Information for the Switch, on page 53
• Displaying the Current State of a Module, on page 54
• Displaying Temperatures for a Module, on page 56
• Connecting to a Module, on page 58
• Saving the Module Configuration, on page 58
• Shutting Down or Starting Up a Module, on page 59
• Purging a Nonfunctioning Module from the Running Configuration, on page 60
• Displaying Power Usage Information, on page 60
• Reload a Module, on page 61
• Rebooting a Switch, on page 62
• Overview of Supervisor Modules, on page 63
• Overview of Power Modes, on page 64
• Overview of Fan Trays, on page 69
Displaying Information About the Installed Hardware Modules
You can display information about the switch hardware and the hardware modules that are installed in the
switch chassis by using the show hardware command.
switch# show hardware
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_seri
es_home.html
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
Software
...
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide
45
To Next Page
Loading...
