EasyManua.ls Logo

Cisco ONS 15454 SDH - Optical Card Transmit and Receive Levels

Cisco ONS 15454 SDH
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-7
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 9 Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling
VLAN-Transparent and VLAN-Specific Services Configuration Example
Note
VLAN-transparent service is also referred to as Ethernet Wire Service (EWS). VLAN-specific service
is also referred to as QinQ tunneling trunk UNI in Metro Ethernet terminology.
A VLAN-specific service on a subinterface coexists with the VLAN-transparent service, often
IEEE 802.1Q tunneling, on a physical interface. VLANs configured for a VLAN-transparent service and
a VLAN-specific service follow the VLAN-specific service configuration. If you need to configure
802.1Q tunneling, configure this VLAN-transparent service in the normal manner, see the “Configuring
IEEE 802.1Q Tunneling” section on page 9-4.
A VLAN-specific service can be any service normally applicable to a VLAN. To configure an ERMS
VLAN-specific service, configure the service in the normal manner.
VLAN-Transparent and VLAN-Specific Services Configuration
Example
In this example, the Gigabit Ethernet interfaces 0 on both the ML-Series card A and ML-Series card C
are the trunk ports in an IEEE 802.1Q tunnel, a VLAN-transparent service. VLAN 10 is used for the
VLAN-transparent service, which would normally transport all customer VLANs on the ML-Series card
As Gigabit Ethernet interface 0. All unspecified VLANs and VLAN 1 would also be tunneled across
VLAN 10.
VLAN 30 is prevented from entering the VLAN-transparent service and is instead forwarded on a
specific-VLAN service, bridging Gigabit Ethernet interface 0 on ML-Series card A and Gigabit Ethernet
interface 0 on ML-Series card B. Figure 9-3 is used as an example to performing configuration examples
9-3, 9-4, and 9-5.
Figure 9-3 ERMS Example
Example 9-3 applies to ML-Series card A.
Example 9-3 ML-Series Card A Configuration
hostname ML-A
bridge 10 protocol rstp
802.1Q Tunnel on VLAN 10
GigabitEthernet Interface 0
ML-Series Card A
VLAN 30
ML-Series Card B
96891
VLAN 30
VLANs 0-29 and 31-4095
VLANs 0-29 and 31-4095
802.1Q Tunnel on VLAN 10
GigabitEthernet Interface 0
ML-Series Card C

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals