Cisco ONS 15454 SDH - Table 18-3 Commands for Monitoring and Verifying MPLS-TE; Monitoring and Verifying MPLS-TE and IP RSVP

18-18
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 18 Configuring Ethernet over MPLS
Monitoring and Verifying MPLS-TE and IP RSVP
!
ip explicit-path identifier 1 enable
next-address 2.1.1.1
next-address 192.168.3.2
next-address 192.168.3.1
next-address 2.2.1.1
next-address 2.2.1.2
next-address 212.212.212.212
!
ip explicit-path identifier 2 enable
next-address 170.170.170.171
next-address 192.168.3.2
next-address 192.168.3.1
next-address 2.2.1.1
next-address 2.2.1.2
next-address 212.212.212.212
!
!
!
!
control-plane
!
!
line con 0
exec-timeout 0 0
line vty 0 4
exec-timeout 0 0
password xxx
no login
Monitoring and Verifying MPLS-TE and IP RSVP
Table 18-3 shows the privileged EXEC commands supported to monitor and verify the state of MPLS-TE
tunnels on the ML-Series cards.
Table 18-3 Commands for Monitoring and Verifying MPLS-TE
Command Purpose
show mpls traffic-eng autoroute
Displays tunnels announced to the
Interior Gateway Protocol (IGP),
including interface, destination, and
bandwidth
show mpls traffic-eng link-management
admission-control
Displays which tunnels were
admitted locally and their parameters
(such as, priority, bandwidth,
incoming and outgoing interface, and
state).
show mpls traffic-eng link-management
advertisements
Displays local link information that
MPLS traffic engineering link
management is currently flooding
into the global traffic engineering
topology.
show mpls traffic-eng link-management
bandwidth-allocation
Displays current local link
information.