Cisco ONS 15454 SDH - E-Series Point-To-Point Ethernet Circuits

23-24
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 23 E-Series and G-Series Ethernet Operation
E-Series Point-to-Point Ethernet Circuits
E-Series Point-to-Point Ethernet Circuits
The ONS nodes can set up a point-to-point (straight) Ethernet circuit as single-card, port-mapped, or
multicard circuit (Figure 23-19).
Figure 23-19 Multicard EtherSwitch Point-to-Point Circuit
Single-card EtherSwitch and port-mapped modes provide a full STS-12c of bandwidth between two
Ethernet circuit endpoints (Figure 23-20).
Figure 23-20 Single-Card EtherSwitch or Port-Mapped Point-to-Point Circuit
Note A port-mapped, point-to-point circuit cannot join an E-Series port-based VLAN, but can transport
external VLANs.
43272
ONS Node 1
ONS Node 2192.168.1.100
255.255.255.0
VLAN test 1
Slot 5, Port 1
192.168.1.75
255.255.255.0
VLAN test 1
Slot 17, Port 1
192.168.1.25
255.255.255.0
VLAN test 1
Slot 4, Port 1
192.168.1.50
255.255.255.0
VLAN test 1
Slot 15, Port 1
ONS Node 3
SONET
Ethernet
ONS 15454 3ONS 15454 2
ONS 15454 1
192.168.1.50
255.255.255.0
VLAN test
Slot 15
192.168.1.25
255.255.255.0
VLAN test
Slot 4
32161