5-11
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 5 Configuring POS
POS Configuration Examples
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
POS Configuration Examples
The following sections show ML-Series card POS configuration examples for connecting to other ONS
Ethernet cards and POS-capable routers. These examples are only some of the ML-Series card
configurations available to connect to other ONS Ethernet cards and POS-capable routers. For more
specifics about the POS characteristics of ONS Ethernet cards, see Chapter 20, “POS on ONS Ethernet
Cards.”
ML-Series Card to ML-Series Card
Figure 5-1 illustrates a POS configuration between two ONS 15454 or ONS 15454 SDH ML-Series
cards.
Figure 5-1 ML-Series Card to ML-Series Card POS Configuration
Example 5-3 shows the commands associated with the configuration of ML-Series card A.
Example 5-3 ML-Series Card A Configuration
hostname ML_Series_A
!
interface FastEthernet0
ip address 192.168.1.1 255.255.255.0
!
interface POS0
ip address 192.168.2.1 255.255.255.0
crc 32
pos flag c2 1
!
router ospf 1
ONS 15454
with ML100T-12
fast ethernet 0
pos 0pos 0
fast ethernet 0
ML_Series_A
SONET/SDH
192.168.1.1
192.168.2.1
192.168.2.2
192.168.3.1
ONS 15454
with ML100T-12
ML_Series_B
83127
To Next Page
Loading...
