Cisco ONS 15454 SDH - Configuration Examples for Cisco IOS CLI Portion of End-To-End RPR-IEEE

26-35
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
Configuration Examples for Cisco IOS CLI Portion of End-to-End RPR-IEEE
Configuration Examples for Cisco IOS CLI Portion of End-to-End RPR-IEEE
The following examples show RPR-IEEE configurations. Example 26-7 is a simple configuration. It
does the minimum needed to bridge the ML-Series card’s Ethernet ports and the ML-Series card’s
RPR-IEEE and leaves the RPR-IEEE characteristics at default. Example 26-8 is a complex example of
RPR-IEEE with multiple bridge groups, configured characteristics, and QoS.
Example 26-7 Configuration Example for Simple RPR-IEEE
version 12.2
no service pad
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime
no service password-encryption
service internal
!
hostname ml
!
boot-start-marker
boot-end-marker
!
enable password x
!
clock timezone PST -8
clock summer-time PDT date Apr 2 2006 2:00 Oct 29 2006 2:00
ip subnet-zero
no ip routing
no ip domain-lookup
!
no mpls traffic-eng auto-bw timers frequency 0
!
bridge irb
!
!
interface GigabitEthernet0
no ip address
no ip route-cache
no ip mroute-cache
bridge-group 10
bridge-group 10 spanning-disabled
!
interface GigabitEthernet1
no ip address
no ip route-cache
no ip mroute-cache
shutdown
!
interface RPR-IEEE0
no ip address
no ip route-cache
rpr-ieee fairness mode aggressive
!
interface RPR-IEEE0.10
encapsulation dot1Q 10
no ip route-cache
no snmp trap link-status
bridge-group 10
bridge-group 10 spanning-disabled
!
ip classless
no ip http server