Cisco ONS 15454 SDH - Verifying and Monitoring RPR-IEEE

26-22
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
Verifying and Monitoring RPR-IEEE
mode dot1q-tunnel
l2protocol-tunnel cdp
l2protocol-tunnel stp
l2protocol-tunnel vtp
no cdp enable
bridge-group 22
bridge-group 22 spanning-disabled
!
interface RPR-IEEE0
ip address 1.1.1.3 255.255.255.0
rpr-ieee fairness mode aggressive
service-policy output EgrNNI
!
interface RPR-IEEE0.20
encapsulation dot1Q 20
no snmp trap link-status
bridge-group 20
bridge-group 20 spanning-disabled
!
interface RPR-IEEE0.22
encapsulation dot1Q 22
no snmp trap link-status
bridge-group 22
bridge-group 22 spanning-disabled
!
interface RPR-IEEE0.30
encapsulation dot1Q 30
no snmp trap link-status
bridge-group 30
bridge-group 30 spanning-disabled
!
ip classless
Verifying and Monitoring RPR-IEEE
After RPR-IEEE is configured, you can use the following commands to verify setup and monitor its
status:
• The show interface rpr-ieee interface-number command (Example 26-3) displays the following
for an interface:
– Primary or secondary status (if RI is activated)
– Active or standby mode (if RI is activated)
– Up or down (pass-through mode) status
– Monitoring status and by extension, general protection status
• The show interface rpr-ieee fairness detail command (Example 26-4) displays the following for
an interface:
– Total bandwidth
– Traffic class configured transmission rates
– Fairness weight settings for the interface
– Instances of congestion
• The show rpr-ieee protection command (Example 26-5) displays the following for an interface:
– Station and neighbor interface MAC addresses