21-2
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 21 Configuring RMON
Configuring RMON
Figure 21-1 Remote Monitoring Example
Configuring RMON
These sections describe how to configure RMON on your ML-Series card:
•
Default RMON Configuration, page 21-2
•
Configuring RMON Alarms and Events, page 21-2 (required)
•
Collecting Group History Statistics on an Interface, page 21-5 (optional)
•
Collecting Group Ethernet Statistics on an Interface, page 21-6 (optional)
Default RMON Configuration
RMON is disabled by default; no alarms or events are configured.
Configuring RMON Alarms and Events
You can configure your ML-Series card for RMON by using the command-line interface (CLI) or an
SNMP-compatible network management station. We recommend that you use a generic RMON console
application on the NMS to take advantage of RMON’s network management capabilities. You must also
configure SNMP on the ML-Series card to access RMON MIB objects. For more information about
configuring SNMP, see Chapter 22, “Configuring SNMP.”
145951
RMON alarms and events
configured. SNMP configured.
RMON history
and statistic
collection enabled.
Workstations
Workstations
Network management station with
generic RMON console application
To Next Page
Loading...
