Cisco ONS 15454 SDH - POS Channel Configuration Example; Figure 10-2 POS Channel Example

10-6
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 10 Configuring Link Aggregation
POS Channel Configuration Example
POS Channel Configuration Example
Figure 10-2 shows an example of POS channel configuration. The associated code is provided in
Example 10-3 (Switch A) and Example 10-4 (Switch B).
Figure 10-2 POS Channel Example
Example 10-3 Switch A Configuration
bridge irb
bridge 1 protocol ieee
!
!
interface Port-channel1
no ip address
no keepalive
bridge-group 1
!
interface FastEthernet0
no ip address
bridge-group 1
!
interface POS0
no ip address
channel-group 1
crc 32
pos flag c2 1
!
interface POS1
no ip address
channel-group 1
crc 32
pos flag c2 1
Example 10-4 Switch B Configuration
bridge irb
bridge 1 protocol ieee
Step 3
Router(config-if)# end
Exits to privileged EXEC mode.
Step 4
Router# copy running-config startup-config
(Optional) Saves the configuration changes to
NVRAM.
Command Purpose
pos 0pos 0
bridge-group 1
bridge-group 1
port-channel 1
bridge-group 1
bridge-group 1
bridge-group 1
port-channel 1
bridge-group 1
pos 1pos 1
83447
SONET STS-N
ML_Series A
ML_Series B