Cisco ONS 15454 SDH - Table 2-1 ML-Series POS and Ethernet Statistics Fields and Buttons; Table 2-2 CTC Display of Ethernet Port Provisioning Status; Chapter 2 CTC Operation

2-2
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 2 CTC Operations
Displaying ML-Series Ethernet Ports Provisioning Information on CTC
Displaying ML-Series Ethernet Ports Provisioning Information
on CTC
The Ethernet port provisioning window displays the provisioning status of the Ethernet ports. Click the
Provisioning > Ether Ports tabs to display this window.
The user must configure ML-Series ports using the Cisco IOS CL; however, the following fields can be
provisioned using CTC: Port Name, Pre-Service Alarm Suppression (PSAS), and Soak Time. Click the
Port Name field to assign a name to the port. For more information about provisioning these fields, refer
to the “Change Card Settings” chapter in the Cisco ONS 15454 Procedure Guide.
“Auto” in a column indicates the port is set to autonegotiate capabilities with the attached link partner.
All ML-Series cards do not display all columns. Ta ble 2 -2 details the information displayed under the
Provisioning > Ether Ports tab:
Table 2-1 ML-Series POS and Ethernet Statistics Fields and Buttons
Button Description
Refresh
Manually refreshes the statistics.
Baseline
Resets the software counters (in that particular CTC client only) temporarily to zero
without affecting the actual statistics on the card. From that point on, only counters
displaying the change from the temporary baseline are displayed by this CTC client.
These new baselined counters are shown only as long as the user displays the
Performance window. If the user navigates to another CTC window and comes back
to the Performance window, the true actual statistics retained by the card are shown.
Auto-Refresh
Sets a time interval for the automatic refresh of statistics.
Table 2-2 CTC Display of Ethernet Port Provisioning Status
Column Description ML1000-2 ML100T-12 ML100X-8
Port The fixed number identifier for the
specific port.
0 or 1 0-11 0-7
Port Name Configurable 12-character
alphanumeric identifier for the port.
User specific User specific User
specific
Admin State Configured port state, which is
administratively active or inactive.
UP and DOWN UP and
DOWN
UP and
DOWN
Link State Status between signaling points at port
and attached device.
UP and DOWN UP and
DOWN
UP and
DOWN
PSAS A check indicates alarm suppression is set on the port for the time designated in the
Soak Time column.
Soak Time Desired soak time in hours and minutes. Use this column when you have checked PSAS
to suppress alarms. Once the port detects a signal, the countdown begins for the
designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can
be set from 0 to 45 in 15 minute increments.
MTU (Maximum Transmission Unit) Largest
acceptable packet size configured for
that port.
Default value is
1500
Default value
is 1500
Default
value is
1500