Cisco ONS 15454 SDH - Configuration Example Using MQC to Configure Simple RPR-IEEE Qos; Configuration Example Using MQC to Configure Complex RPR-IEEE Qos

26-21
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Chapter 26 Configuring IEEE 802.17b Resilient Packet Ring
Configuration Example Using MQC to Configure Simple RPR-IEEE QoS
Configuration Example Using MQC to Configure Simple RPR-IEEE QoS
The following is an example of the configuration process for the three RPR-IEEE service classes:
Example 26-1 Configuration Example for a Simple RPR-IEEE QoS Configuration
class-map match-any DataHi
match cos 2 3 4
class-map match-any Control
match cos 5 6 7
policy-map EgrNNI
class Control
set rpr-ieee service-class a
class DataHi
set rpr-ieee service-class b
class class-default
set rpr-ieee service-class c
!
interface RPR-IEEE0
no ip address
rpr-ieee protection pref jumbo
rpr-ieee tx-traffic rate-limit high 100 east
rpr-ieee tx-traffic rate-limit high 100 west
rpr-ieee tx-traffic rate-limit medium 200 east
rpr-ieee tx-traffic rate-limit medium 200 west
service-policy output EgrNNI
Configuration Example Using MQC to Configure Complex RPR-IEEE QoS
The following is an example of a more complex RPR-IEEE QoS configuration:
Example 26-2 Configuration Example for a Complex RPR-IEEE
class-map match-all classA
match bridge-group 22
!
!
policy-map EgrNNI
class classA
set rpr-ieee service-class a
class class-default
set rpr-ieee service-class c
!
bridge irb
!
!
interface GigabitEthernet0
no ip address
mode dot1q-tunnel
l2protocol-tunnel cdp
l2protocol-tunnel stp
l2protocol-tunnel vtp
no cdp enable
bridge-group 20
bridge-group 20 spanning-disabled
!
interface GigabitEthernet1
no ip address