A-18
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
[no] rpr-ieee protection request manual-switch {east | west}
[no] rpr-ieee protection request manual-switch {east | west}
Use this command to trigger a manual-switch protection event on the specified IEEE 802.17b based RPR
span. Use the no form of this command to deactivate the switch.
Syntax Description
Defaults N/A
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines IEEE 802.17b based RPR switching options are similar to the path protection and BLSR protection
switching options, but RPR-IEEE switching is only available at the CLI and not in CTC.
In this command, protection can be shortened to prot and request can be shortened to req.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee prot req manual-switch east
Related Commands rpr-ieee protection request forced-switch
Parameter Description
east Pertains to configuration for eastbound span traffic.
west Pertains to configuration for westbound span traffic.
To Next Page
Loading...
