Cisco ONS 15454 SDH - Page 496

A-20
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
rpr-ieee protection timer fast rate {east | west}
rpr-ieee protection timer fast rate {east | west}
Use this command to configure the fast protection timer value for the specified IEEE 802.17b based RPR
span.
Syntax Description
Defaults N/A
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines This rate determines how quickly the fast protection timer sends a protection message after a protection
event occurs.
In this command, protection can be shortened to prot.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee prot timer fast 5 east
Related Commands rpr-ieee protection timer slow
Parameter Description
east Pertains to configuration for eastbound span traffic.
west Pertains to configuration for westbound span traffic.
rate The rate, expressed in milliseconds, at which the fast protection timer sends
a protection message. This occurs after a protection event on a particular
(east or west) span. Range is 1 to 20 milliseconds.