Cisco ONS 15454 SDH - Page 503

A-27
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
[no] rpr-ieee ri {primary | secondary} delay interval
[no] rpr-ieee ri {primary | secondary} delay interval
Use this command to change the soak time for a primary card in active mode. Use the no form of this
command to set the timer to default.
Syntax Description
Command Default The default is 3,000 milliseconds.
Command Modes IEEE 802.17b based RPR interface configuration
Usage Guidelines None.
Examples In this example, interface is shortened to int.
router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee ri primary delay 1000
Related Commands rpr-ieee ri mode {primary | secondary}
Parameter Description
primary Single traffic queue mode.
secondary Dual traffic queue mode.
interval Interval that the active mode timer waits before switching to the secondary
card. Range is 1,000 to 20,000 milliseconds.