A-46
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Appendix A Command Reference
show interface rpr-ieee interface-number
show interface rpr-ieee interface-number
Use this command to display the status of chosen IEEE 802.17b based RPR interface.
Syntax Description
Defaults N/A
Command Modes Privileged exec
Usage Guidelines This command can be used to help diagnose and isolate IEEE 802.17b based RPR interface or
SONET/SDH problems.
In this command, interface can be shortened to int.
The rpr-ieee tx-traffic rate-limit high command shows the Class A1 rate range as 0 to 1161 Mbps
Note
If the Class A1transmit rate is set to 5 Mbps , this command does not provide full interface information
as it does for other typical values (3, 4, 6, 8, and 10 Mbps).
Examples
router# show interface rpr-ieee 0
RPR-IEEE0 is up, line protocol is up
Hardware is RPR-IEEE Channelized SONET, address is 0005.9a3c.59c0 (bia 0005.9a3c.59c0)
MTU 1500 bytes, BW 96768 Kbit, DLY 100 usec,
reliability 255/255, txload 128/255, rxload 128/255
Encapsulation: RPR-IEEE,
West Span: loopback not set
East Span: loopback not set
MAC passthrough not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
West Span:5 minutes output rate 96361986 bits/sec, 76243 packets/sec
5 minutes input rate 89824634 bits/sec, 71241 packets/sec
East Span: 5 minutes output rate 71872254 bits/sec, 56867 packets/sec
5 minutes input rate 95391157 bits/sec, 75475 packets/sec
3402516571 packets input, 4038397818 bytes
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
3 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast
0 input packets with dribble condition detected
1355393210 packets output, 4104587724 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
Parameter Description
interface-number Number of the IEEE 802.17b based RPR interface (0–1)
To Next Page
Loading...
