Cisco ONS 15454 SDH - Hairpin Circuits; Cross-Connect Loopbacks

Contents
viii
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
CHAPTER 11 Configuring Networking Protocols 11-1
Basic IP Routing Protocol Configuration 11-1
RIP 11-2
EIGRP 11-2
OSPF 11-2
BGP 11-3
Enabling IP Routing 11-3
Configuring IP Routing 11-4
Configuring RIP 11-4
RIP Authentication 11-7
Summary Addresses and Split Horizon 11-8
Configuring OSPF 11-9
OSPF Interface Parameters 11-13
OSPF Area Parameters 11-14
Other OSPF Behavior Parameters 11-16
Change LSA Group Pacing 11-18
Loopback Interface 11-19
Monitoring OSPF 11-19
Configuring EIGRP 11-20
EIGRP Router Mode Commands 11-22
EIGRP Interface Mode Commands 11-23
Configure EIGRP Route Authentication 11-25
Monitoring and Maintaining EIGRP 11-26
Border Gateway Protocol and Classless Interdomain Routing 11-27
Configuring BGP 11-27
Verifying the BGP Configuration 11-28
Configuring IS-IS 11-29
Verifying the IS-IS Configuration 11-30
Configuring Static Routes 11-31
Monitoring Static Routes 11-32
Monitoring and Maintaining the IP Network 11-33
Understanding IP Multicast Routing 11-33
Configuring IP Multicast Routing 11-34
Monitoring and Verifying IP Multicast Operation 11-35
CHAPTER 12 Configuring IRB 12-1
Understanding Integrated Routing and Bridging 12-1
Configuring IRB 12-2