Cisco Secure Firewall 3100 User Manual

Monitoring Multi-Instance Mode
This section helps you troubleshoot and diagnose your multi-instance mode chassis and instances.
Monitoring Multi-Instance Setup
show system detail
This FXOS command shows the current mode, Native or Container. If the mode is Native (also known as
appliance mode), you can convert to multi-instance (Container) mode. Note that the prompt/name in
multi-instance mode is generic "firepower-<model>" while the prompt in appliance mode is the hostname
you set for the threat defense (by default "firepower")
firepower # show system detail
Systems:
Name: firepower
Mode: Stand Alone
System IP Address: 172.16.0.50
System IPv6 Address: ::
System Owner:
System Site:
Deploy Mode: Native
Description for System:
firepower #
scope system > show
This FXOS command shows the current mode in a table format. Note that the prompt/name in multi-instance
mode is generic "firepower-<model>" while the prompt in appliance mode is the hostname you set for the
threat defense.
firepower-3110# scope system
firepower-3110 /system # show
Systems:
Name Mode Deploy Mode System IP Address System IPv6 Address
---------- ----------- ----------- ----------------- -------------------
firepower-3110
Stand Alone Container 10.89.5.42 ::
3110-1# scope system
3110-1 /system # show
Systems:
Name Mode Deploy Mode System IP Address System IPv6 Address
---------- ----------- ----------- ----------------- -------------------
3110-1 Stand Alone Native 10.89.5.41 ::
3110-1 /system #
Multi-Instance Mode for the Secure Firewall 3100
62
Multi-Instance Mode for the Secure Firewall 3100
Monitoring Multi-Instance Mode

Cisco Secure Firewall 3100 Specifications

General

Brand	Cisco
Model	Secure Firewall 3100
Category	Server
Language	English