Cisco SG350-10P Administration Guide

20
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 380
Security: SSH Server
This section describes how to establish an SSH session on the device.
It covers the following topics:
•Overview
• Common Tasks
• SSH User Authentication
• SSH Server Authentication
Overview
The SSH Server feature enables a remote users to establish SSH sessions to the device. This
is similar to establishing a telnet session, except the session is secured.
The device, as a SSH server, supports SSH User Authentication which authenticates a remote
user either by password, or by public key. At the same time, the remote user as a SSH client
can perform SSH Server Authentication to authenticate the device using the device public key
(fingerprint).
SSH Server can operate in the following modes:
• By Internally-generated RSA/DSA Keys (Default Setting)—An RSA and a DSA
key are generated. Users log on the SSH Server application and are automatically
authenticated to open a session on the device when they supply the IP address of the
device.
• Public Key Mode—Users are defined on the device. Their RSA/DSA keys are
generated in an external SSH server application, such as PuTTY. The public keys are
entered in the device. The users can then open an SSH session on the device through
the external SSH server application.

Cisco SG350-10P Specifications

General

Product Name	Cisco SG350-10P
Category	Switch
Ports	10
PoE Ports	8
PoE Power Budget	62W
Switching Capacity	20 Gbps
Forwarding Rate	14.88 Mpps
Layer	Layer 3
Power Supply	Internal
Relative Humidity	10% to 90% non-condensing
MAC Address Table Size	8K
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Operating Altitude	Up to 3, 000 meters