To enable inter-Data Node communications over eth2 or the eth2/eth3 port channel,
you must deploy 1 switch that supports 10G speeds. Configure a public LAN or VLANfor
Data Nodes eth0 communications with the SMCand Flow Collectors, and an isolated
LANor VLANfor inter-Data Node communications. You can share these switches with
other appliances, but create separate LANs or VLANs for the additional appliance traffic.
See the following diagram for an example:
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 18 -
Data Store Deployment Prerequisites and Recommendations
To Next Page
Loading...
