3. Last, update your Flow Collector to the latest version and patch. See the update
guides for more information on updating to the current version, and patch
readmes for more information on patch updates.
After you update your Flow Collector, for each of your Flow Collectors, repeat the
process described in Flow Collector Configuration for Use with a Data Store
of Flow Collector installation and initial configuration, configuration through
Appliance Setup Tool, and Central Management configuration for your remaining
Flow Collectors.
4.
After you have deployed and configured all of your Flow Collectors, initialize and
configure the Data Store, as described in Data Store Initialization and
Configuration.
Data Store Initialization and Configuration
After you deploy and configure your SMC, Data Nodes, and Flow Collectors, initialize
and configure the Data Store. Make sure that all of your SMCs, Data Nodes, and Flow
Collectors are updated to the latest version and patch before your proceed.
Perform the following:
1.
First, check Central Management to ensure that your SMCis managing the
required appliances:
l all Data Nodes
l all Flow Collectors
l secondary SMC, if you deployed one
Verify that your Data Nodes and Flow Collectors are
managed through Central Management:
Before You Begin
l Make a list of all of the Data Node and Flow Collector IPaddresses and host
names that you expect to be managed in Central Management.
l Log into the SMCWeb App as a system administrator, and go to Central
Management.
Procedure
l In the Appliance Inventory, compare your list of Data Nodes and Flow
Collectors, and secondary SMC if you deployed one, to the list in the
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 30 -
Data Store Installation
To Next Page
Loading...
Need help?
General
