Cisco Stealthwatch - Data Store-Compatible Appliances (SMC 2210, FC 4210)

This is the last configuration option in First Time Setup. Your appliance restarts
and implements the changes. On completion, the Login page opens.
What to Do Next
l
Change user passwords. See Changing the Sysadmin User Password for more
information.
Data Store-Compatible Appliances (SMC 2210, FC 4210)
For the SMC2210 and FC4210, First Time Setup displays the following configuration:
1. Configure the eth0 management physical port
2. Configure the appliance's IPaddress and management information
3. Configure Data Store compatibility
4. Configure Security Analytics and Logging On Prem use
Configure the eth0 management physical port
If you configure an SMCor Flow Collector that is Data Store-compatible, and deploy a
Data Store, you can optionally configure eth0 as an SFP+ DAC port, instead of the
default BASE-T copper port. For these appliances, this is the first configuration in First
Time Setup.
Before You Begin
l If you are configuring a Data Node, or Data Store-compatible SMCor Flow
Collector, see the Stealthwatch specification sheet for your appliance for
information on the supported SFP+and BASE-T ports.
l
If you are configuring a Data Node, go to Data Node Configuration.
l If you are configuring any other Stealthwatch appliance besides Data Store-
compatible appliances, see General Stealthwatch Appliance Configuration.
Procedure
1.
Log in to the System Configuration program:
l
Type root, and then press Enter.
root permissions are required to properly configure Data Store
compatibility.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 74 -
Appendix B.Stealthwatch Hardware Installation