Cisco Stealthwatch - Page 73

Configure the appliance's IPaddress and management
information:
You configure your appliance's eth0 management IPaddress and related information in
First Time Setup. For most appliances, this is the first configuration in First Time Setup.
Before You Begin
l
If you are configuring a Data Node, go to Data Node Configuration.
l
If you are configuring a Data Store-compatible SMCor Flow Collector, go to Data
Store-Compatible Appliances (SMC 2210, FC 4210).
l If you are configuring any other Stealthwatch appliance, start with step 1.
Procedure
1.
Log in to the System Configuration program:
l If you are configuring a Data Node or Data Store-compatible appliance, type
root, and then press Enter. If you are configuring any other appliance, type
sysadmin, and then press Enter.
root permissions are required to properly configure the Data Store
and Data Store compatibility.
l
When the password prompt appears, type lan1cope, and then press Enter.
l
At the next prompt, type SystemConfig, and then press Enter.
2.
If this is the first time you entered System Configuration on this appliance, First
Time Setup starts.
Otherwise, the System Configuration menu opens. Select Management, and
then press Enter.
3. Enter an IPaddress for this appliance.
4. Enter a Netmask for the network.
5. Enter a Gateway address for this appliance's IPaddress.
6. Enter a Broadcast address for the appliance.
7. Enter a Hostname for your appliance.
8. Enter a Domain for your appliance.
9. Select Select, then select Yes to confirm your entries.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 73 -
Appendix B.Stealthwatch Hardware Installation