Appendix B.Stealthwatch Hardware
Installation
This section covers installing your appliances in your environment. It includes:
l
Mounting Your Appliance
l
Connecting Your Appliance to the Network
l
Connecting to Your Appliance
l
Configuring Network Settings Using First Time Setup
Mounting Your Appliance
You can mount Stealthwatch appliances directly in a standard 19'' rack or cabinet, any
other suitable cabinet, or on a flat surface. When mounting an appliance in a rack or
cabinet, follow the instructions included in the rail mounting kits. When determining
where to place an appliance, make sure that clearance to the front and rear panels is as
follows:
l The front-panel indicators can be read easily
l Access to ports on rear panel is sufficient for unrestricted cabling
l The rear panel power inlet is within reach of a conditioned AC power source.
l Airflow around the appliance and through the vents is unrestricted.
Hardware Included with the Appliance
The following hardware is included with Stealthwatch appliances:
l AC power cord
l Access keys (for front face plate)
l Rail kit for rack mounting or mounting ears for smaller appliances
l For the Flow Collector 5210, a 10 GB SFP cable
Additional Required Hardware
You must provide the following additional required hardware:
l Mounting screw for a standard 19" rack
l Uninterruptible power supply (UPS) for each appliance you are installing
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 67 -
Appendix B.Stealthwatch Hardware Installation
To Next Page
Loading...
