Appendix A.Installation Preparation
Installation Warnings
Read the Regulatory and Compliance Safety Information document before installing
the Stealthwatch Data Store appliances.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause
bodily injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that
accompanied this device.
SAVE THESE INSTRUCTIONS
Statement 1005—Circuit Breaker
This product relies on the building’s installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than: USA:
120, 15 A (EU: 250V, 16A)
Statement 1004—Installation Instructions
Read the installation instructions before using, installing or connecting the
system to the power source.
Statement 12—Power Supply Disconnection Warning
Before working on a chassis or working near power supplies, unplug the power
cord on AC units; disconnect the power at the circuit breaker on DC units.
Statement 43—Jewelry Removal Warning
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 60 -
Appendix A.Installation Preparation
To Next Page
Loading...
