Before You Begin
l
Log into a Data Node console as root.
Procedure
1.
Enter su - dbadmin and press Enter to run the following commands as the
dbadmin user.
2.
From the command prompt, enter /opt/vertica/bin/admintools -t
start_db -d sw and press Enter to start the Data Store.
If you attempt to restart the Data Store database, and the console notes
Data Nodes that could not be reached by SSH, enable SSH for these Data
Nodes, then try this procedure again.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 59 -
Data Store Deployment Troubleshooting
To Next Page
Loading...
