Cisco Stealthwatch - Page 75

l
When the password prompt appears, type lan1cope, and then press Enter.
l
At the next prompt, type SystemConfig, and then press Enter.
2.
If this is the first time you entered System Configuration on this appliance, First
Time Setup starts and displays Port Order configuration. Skip to step 5.
Otherwise, the System Configuration menu opens. Select Management, and
then press Enter.
3. From the System Configuration menu, select Network, and then press Enter.
4. Select Port Order, then press Enter.
5.
You have the following options:
l
Select LOM to configure your appliance for use a BASE-Tcopper port for
eth0.
l
Select SFP+ to configure your appliance to use an SFP+fiber port for eth0.
6. Select OK to confirm your selection.
What to Do Next
l Configure the eth0 management port's IPaddress and management information.
See the next procedure.
Configure the appliance's IPaddress and management
information:
You configure your appliance's eth0 management IPaddress and related information in
First Time Setup. For Data Store-compatible appliances, this configuration occurs after
configuring the eth0 physical management port.
Before You Begin
l If you are configuring a Data Store-compatible SMCor Flow Collector, after you
configure Port Order, the First Time Setup wizard displays the eth0 management
configuration. Go to step 3.
Procedure
1.
Log in to the System Configuration program:
l
If you are configuring a Data Store-compatible appliance, type root, and
then press Enter.
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 75 -
Appendix B.Stealthwatch Hardware Installation