l Configures inter-Data Node communication.
l Initializes the Data Store.
l Finalizes Data Store setup.
At several of these steps, the wizard takes several or minutes to update the
configuration before continuing to the next step in the process. After the wizard
finalizes Data Store setup, check the Central Management inventory to verify that
all appliances are Up. Your Stealthwatch deployment with a Data Store is
complete.
Assign the dbadmin and readonlyuser passwords when prompted by the
wizard. Each password must comply with the following requirements:
l at least 1 number
l at least 1 lower case character
l at least 1 upper case character
l
at least 1 special character from the following list:
<>.,?/'"|:;`~!@#$%^&*()-_+={}[]
l at least 8 characters, no maximum length
l only ASCII-encoded characters
Initialize the Data Store
Before You Begin
l
Enable passwordless SSH in SystemConfig.
l Make sure that all appliances in Central Management are Up before you
continue.
Procedure
l
From the Data Store menu in SystemConfig, select Initialize Data Store.
Follow the steps in the wizard. Note that it may take several minutes or more
to complete each step in the process.
After the Data Store initializes and the wizard finalizes Data Store setup,
check that all appliances in Central Management are Up. Your Stealthwatch
deployment with a Data Store is complete.
What to Do Next
l If you do not have a UDPDirector, Flow Sensor, or secondary SMC,
configure your flow interface statistics data retention, as described in Flow
© 2021 Cisco Systems, Inc. and/or its affiliates. All rights reserved. - 32 -
Data Store Installation
To Next Page
Loading...
Need help?
General
