LAB 2: PBX, Voicemail & DialPlan
Cisco Unified Communications Technical Training
Page 18 of 171
o Check “Enable” and select 1 for number of “Hunt Groups.” Configure the timeout as 3
seconds. Configure the first Pilot # as 501. Use the default Hunt type (sequential). Select
“No Answer Forward to” destination as Voicemail. Click on “Members” button.
Select 201 and 202 and click Add to make them members of the huntgroup. Click OK.
17. Click on the “Dial plan” tab. Click on Configure button for Outgoing Numbers. Click Add.
Configure the blocked digit pattern as follows:
Permissions: Blocked
Access Code: 9
Begins with: 1510
Number of digits: 11
The dial-pattern shown should be 91510xxxxxxx. Click OK.
This will block all outbound dialing to U.S.A 510 area code.
To Next Page
Loading...