A: memb state UP, lead state PRIMARY, mgmt services state: UP
B: memb state UP, lead state SUBORDINATE, mgmt services state: UP
heartbeat state PRIMARY_OK
INTERNAL NETWORK INTERFACES:
eth1, UP
eth2, UP
HA READY <<<<<<<<<<<<<←---------------- HA is READY
Detailed state of the device selected for HA storage:
Chassis 1, serial: FOX1344G1R1, state: active
Chassis 2, serial: FOX1318GDKR, state: active
FI-A#
Step 15 Disable fabric evacuation and verify that traffic is flowing in both fabric interconnects.
Step 16 Apply the port license to the fabric interconnect.
Repacking the Cisco UCS Fabric Interconnect for Return
Shipment
If you need to return the fabric interconnect, remove the chassis from the rack by following the steps in
Removing a Cisco UCS Fabric Interconnect, on page 38, and repack it for shipment. If possible, use the
original packing materials and container to repack the chassis. Contact your Cisco customer service
representative to arrange for return shipment to Cisco.
Cisco UCS 6300 Series Fabric Interconnect Hardware Installation Guide
43
Installing the Cisco UCS 6300 Series Fabric Interconnect
Repacking the Cisco UCS Fabric Interconnect for Return Shipment
To Next Page
Loading...
Need help?
General
