Cisco UCS B200 M4 - Installing a Blade Server; Installing a Half-width Blade Server

CHAPTER 2
Installing a Blade Server
This chapter contains the following sections:
•
Installing a Half-width Blade Server, page 7
•
Server Configuration, page 9
•
Powering Off a Blade Server Using the Power Button, page 9
•
Removing a Blade Server, page 9
•
Server Troubleshooting, page 10
Installing a Half-width Blade Server
UCS B200 M4, UCS B200 M3, and UCS B22 M3 half-width blade servers are interoperable in a UCS chassis
with any other UCS blade servers, including prior generation B200 M2 and B200 M1 servers, or other UCS
B-Series blade servers. To install a half-width blade server, follow these steps:
Cisco UCS B200 M4 Blade Server Installation and Service Note
7