Cisco UCS B200 M4 - Internal Components

Internal Components
Figure 8: Inside View of the UCS B200 M4 Blade Server
Modular storage subsystem connector2SD card slots1
DIMM slots4USB connector
An internal USB 2.0 port is supported.
A 16 GB USB drive
(UCS-USBFLSHB-16GB) is available
from Cisco. A clearance of 0.950
inches (24.1 mm) is required for the
USB device to be inserted and
removed.
3
CPU heat sink install guide pins6Front heat sink and CPU 15
CMOS battery8Rear heat sink and CPU 27
DIMM diagnostic LED button10Trusted Platform Module (TPM)9
Adapter slot 212Adapter slot 111
When the storage module is installed, the USB connector is underneath it. Use the small cutout opening
in the storage module to visually determine the location of the USB connector when you need to insert it.
Note
Cisco UCS B200 M4 Blade Server Installation and Service Note
15
Servicing a Blade Server
Internal Components