Procedure
Step 1
Loosen the captive screw on the front of the blade.
Step 2
Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade server.
Step 3
Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its
weight.
Step 4
Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling
it into another slot.
Step 5
If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.
Server Troubleshooting
For general troubleshooting information, see the see the Cisco UCS Manager B-Series Troubleshooting Guide.
Cisco UCS B200 M4 Blade Server Installation and Service Note
10
Installing a Blade Server
Server Troubleshooting
To Next Page
Loading...
