Chapter 1 Installing the Devices
Pair Devices
Pairing a VEN402 Client Device
Complete the following steps to pair the VEN401 access point with a VEN402 client
device.
Note: The VEN402 can only be paired with a VEN401.
1 Press the WPS button on the client device. The WPS LED flashes.
Note: You have 2 minutes to perform step 2.
2 Click the WPS button on the VEN401 Access Point. The WPS LED flashes. When
the devices are paired, the WPS LED remains lit for a short time.
Note: The WPS LED indicator remains off when the WPS is idle. This is a normal
condition.
Pairing Other Client Devices
If you wish to pair the VEN401 access point with another client device, such as a
Cisco wireless set-top, refer to the documentation for that device for instructions.
To Next Page
Loading...
