Chapter 2 Web-Based User Interface
2 Select one of the following options from the Mode drop-down menu:
Local—Select this option to retrieve logs from the local server. When this
option is selected, the Server IP and Server UDP Port fields are not
applicable.
Remote—Select this option to send logs to a system server. When this option
is selected, the Server IP and Server UDP Port fields are required.
3 Enter the Server IP Address of your syslog server.
4 Enter the Server UDP Port of your syslog server.
5 Do you wish to receive email alerts if a log message is detected?
If yes, select the Enabled radio button for the Email Alerts field and complete
the following fields:
– SMTP Mail Server—Enter the address (domain name) or IP address of
the SMTP (Simple Mail Transport Protocol) Server you use for outgoing
E-mail.
– Email To Address—Enter the E-mail address the alert is to be sent to.
– Email From Address—Enter the E-mail will show this address as the
Sender's address.
If no, select the Disabled radio button for the Email Alerts field and skip to
the last step.
6 Click the Save Settings button to apply your changes or Cancel Changes button
to cancel.
View Log
Complete the following steps to view the logs.
1 Click the View Log button. A new window appears with the log data.
2 Click the Refresh button to update the log.
3 Click the Clear button to clear all the information in the current log.
4 Click the Close button to close window.
To Next Page
Loading...
Need help?
General
