Step 1 Select Security > Configure WPA-PSK Complexity.
Step 2 Check Enable to enable the WAP device to check the WPA-PSK keys against the configured criteria. If disabled, none
of the configured settings are used. The WPA-PSK Complexity is disabled by default.
Step 3 Configure these parameters:
• WPA-PSK Minimum Character Class — Choose the minimum number of character classes that must be represented
in the key string. The four possible character classes are uppercase letters, lowercase letters, numbers, and special
characters available on a standard keyboard. The default value for this field is 3. The range can be between 0-4
characters.
• WPA-PSK Different from Current — Check Enable to enable users to configure a different key after their current
key expires. If disabled, users can use the old or previous key after their current key expires.
• Maximum WPA-PSK Length — Enter a key length value. The maximum key length in number of characters is
from 32 to 63. The default is 63.
• Minimum WPA-PSK Length — Enter a key length value. The minimum key length in number of characters is
from 8 to 16. The default is 8.
Step 4 Click Apply.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
46
System Configuration
Configure WAP-PSK Complexity
To Next Page
Loading...
