• Hybrid Spectrum Analyzer—In hybrid mode, client connections are guaranteed but degradation is expected
throughout.
• 3+1 Spectrum Analysis— In 3+1 mode, clients connect to 3x3 chains, while spectrum analysis is done on 1x1
chain.
• Disabled—The default is Disabled
Step 6 Click Configure TSPEC and configure the following parameters:
• TSPEC Violation Interval — In the TSPEC Violation Interval field, enter the time interval in seconds for the WAP
device to report associated clients that do not adhere to mandatory admission control procedures. The reporting
occurs through the system log and SNMP traps. Enter a time from 0 to 900 seconds. The default is 300 seconds.
• TSPEC Mode — Regulates the overall TSPEC mode on the WAP device. By default, the TSPEC mode is off. The
options are:
• On — The WAP device handles TSPEC requests according to the TSPEC settings that you configure on the
Radio page.
• Off — The WAP device ignores TSPEC requests from client stations.
• TSPEC Voice ACM Mode — Regulates mandatory admission control (ACM) for the voice access category. By
default, TSPEC Voice ACM mode is off. The options are:
• On — A station is required to send a TSPEC request for bandwidth to the WAP device before sending or
receiving a voice traffic stream. The WAP device responds with the result of the request, which includes the
allotted medium time if the TSPEC was admitted.
• Off — A station can send and receive the voice priority traffic without requiring an admitted TSPEC. The WAP
device ignores voice TSPEC requests from client stations.
• TSPEC Voice ACM Limit — The upper limit on the amount of traffic that the WAP device attempts to transmit
on the wireless medium using a voice AC to gain access. The default limit is 20 percent of total traffic.
• TSPEC Video ACM Mode — Regulates mandatory admission control for the video access category. By default,
TSPEC Video ACM mode is off. The options are:
• On — A station is required to send a TSPEC request for bandwidth to the WAP device before sending or
receiving a video traffic stream. The WAP device responds with the result of the request, which includes the
allotted medium time if the TSPEC was admitted.
• Off — A station can send and receive video priority traffic without requiring an admitted TSPEC; the WAP
device ignores video TSPEC requests from client stations.
• TSPEC Video ACM Limit — The upper limit on the amount of traffic that the WAP device attempts to transmit
on the wireless medium using a video AC to gain access. The default limit is 15 percent of total traffic.
• TSPEC AP Inactivity Timeout — The amount of time for a WAP device to detect a downlink traffic specification
as idle before deleting it. The valid integer range is from 0 to 120 seconds and the default is 30 seconds.
• TSPEC Station Inactivity Timeout — The amount of time for a WAP device to detect an uplink traffic specification
as idle before deleting it. The valid integer range is from 0 to 120 seconds and the default is 30 seconds.
• TSPEC Legacy WMM Queue Map Mode — Check Enable to enable the intermixing of legacy traffic on queues
operating as ACM. By default, this mode is off.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
51
Wireless
Radio
To Next Page
Loading...
