Cisco WAP150 - Page 86

Common Configuration Settings and Parameters that are Propagated in Single Point Setup
WPA-PSK ComplexityNetworks
Cisco Umbrella (Except Device Tag)Time Settings
PnP (Plug and Play)LLDP (Except POE Priority Configuration)
Radio Configuration Settings and Parameters that are Propagated in Single Point Setup
Wireless Network Mode
Fragmentation Threshold
RTS Threshold
Rate Sets
Channel
Protection
Fixed Multicast Rate
Broadcast or Multicast Rate Limiting
Wireless Band Selection
Short Guard Interval Supported
Radio Configuration Settings and Parameters that are Not Propagated in Single Point Setup
Channel
Beacon Interval
DTIM Period
Maximum Stations
Transmit Power
Other Configuration Settings and Parameters that are Not Propagated in Single Point Setup
Port Settings
Utilization Threshold
VLAN and IPv4Bonjour
BridgeIPv6 Address
Packet CaptureIPv6 Tunnel
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
76
Single Point Setup
Configuration Parameters Propagated and Not Propagated to Single Point Setup Access Points