Getting Started
Using the Access Point Setup Wizard
Cisco WAP131 and WAP351 Administration Guide 11
1
STEP 3 Launch a web browser, such as Microsoft Internet Explorer.
STEP 4 In the address bar, enter the default DHCP address and press the Enter key.
STEP 5 Enter the default user name of cisco and password of cisco in the Username and
Password fields.
STEP 6 Click Log In. The Access Point Setup Wizard appears.
Follow the Setup Wizard instructions to finish the WAP device installation. We
strongly recommend that you use the Setup Wizard for the first installation. See
Using the Access Point Setup Wizard for more information.
Logging Out
By default, the configuration utility logs out after 10 minutes of inactivity. See
HTTP/HTTPS Service for instructions on changing the default timeout period.
To log out, click Logout in the top right corner of the configuration utility.
Using the Access Point Setup Wizard
The first time that you log into the WAP device (or after it has been reset to the
factory default settings), the Access Point Setup Wizard appears to help you
perform initial configuration.
NOTE If you click Cancel to bypass the wizard, the Change Password page appears. You
can then change the default password for logging in (see Changing the Default
Password for more information). For all other settings, the factory default
configurations apply.
To Next Page
Loading...
Need help?
General
