Cisco WAP351 Administration Guide

1
Cisco WAP131 and WAP351 Administration Guide 9
Getting Started
This chapter provides an introduction to the web-based Configuration Utility of the
Cisco WAP131 and WAP351 Wireless-N Dual Radio Access Points. It includes
these topics:
• Getting Started with the Configuration
• Using the Access Point Setup Wizard
• Changing the Default Password
• Quick Start Configuration
• Window Navigation
Getting Started with the Configuration
This section describes system requirements and how to access the web-based
Configuration Utility.
Supported Browsers
Before you begin to use the configuration utility, make sure that you have a
computer with Internet Explorer 7.0 or later, Firefox 3.0 or later, Chrome 5.0 or later,
or Safari 3.0 or later.
Browser Restrictions
• If you are using Internet Explorer 6, you cannot directly use an IPv6 address
to access the WAP device. You can, however, use the Domain Name System
(DNS) server to create a domain name that contains the IPv6 address, and
then use that domain name in the address bar in place of the IPv6 address.

Cisco WAP351 Specifications

General

Brand	Cisco
Model	WAP351
Category	Wireless Access Point
Language	English