Cisco WAP351 - Ipv6 Setting

LAN
IPv6 Setting
Cisco WAP131 and WAP351 Administration Guide 70
4
• Static IP Address, Subnet Mask, and Default Gateway—If you want to
assign a static IP address, enter the IP information in these fields.
• Domain Name Servers—Select one of the following options:
- Dynamic—The WAP device acquires the DNS server addresses from a
DHCP server on the LAN.
- Manual—Manually configure one or more DNS server addresses. Enter
up to two IP addresses in the fields provided.
STEP 3 Click Save. The changes are saved to the Startup Configuration.
NOTE After new settings are saved, the corresponding processes may be stopped and
restarted. When this condition happens, the WAP device may lose connectivity. We
recommend that you change the WAP device settings when a loss of connectivity
will least affect your wireless clients.
IPv6 Setting
Use the IPv6 Setting page to configure the WAP device to use IPv6 address and
IPv6 tunnel.
To configure IPv6 address settings:
STEP 1 Select LAN > IPv6 Setting.
STEP 2 Configure these parameters:
• IPv6 Connection Type—Choose how the WAP device obtains an IPv6
address:
- DHCPv6—The IPv6 address is assigned by a DHCPv6 server.
- Static IPv6—Manually configure the IPv6 address. The IPv6 address
should be in a form similar to xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
(2001:DB8::CAD5:7D91).
• IPv6 Administrative Mode—Enables or disables IPv6 management access.
• IPv6 Auto Configuration Administrative Mode—Enables or disables IPv6
automatic address configuration on the WAP device.