Cisco WAP351 - Page 71

LAN
IPv6 Setting
Cisco WAP131 and WAP351 Administration Guide 71
4
When enabled, the WAP device learns its IPv6 addresses and gateway by
processing the Router Advertisements received on the LAN port. The WAP
device can have multiple autoconfigured IPv6 addresses.
• Static IPv6 Address—The static IPv6 address. The WAP device can have a
static IPv6 address even if addresses have already been configured
automatically.
• Static IPv6 Address Prefix Length—The prefix length of the static address,
which is an integer in the range of 0 to 128. The default is 0.
• Static IPv6 Address Status—Select one of the following options:
- Operational—The IP address has been verified as unique on the LAN
and is usable on the interface.
- Tentative—The WAP device initiates a duplicate address detection
(DAD) process automatically when a static IP address is assigned. An
IPv6 address is in the tentative state while it is being verified as unique on
the network. While in this state, the IPv6 address cannot be used to
transmit or receive ordinary traffic.
- Blank (no value)—No IP address is assigned or the assigned address is
not operational.
• IPv6 Autoconfigured Global Addresses—If the WAP device has been
assigned one or more IPv6 addresses automatically, the addresses are
listed.
• IPv6 Link Local Address—The IPv6 address used by the local physical link.
The link local address is not configurable and is assigned by using the IPv6
Neighbor Discovery process.
• Default IPv6 Gateway—The statically configured default IPv6 gateway.
• IPv6 Domain Name Servers—Select one of the following options:
- Dynamic—The DNS name servers are learned dynamically through
DHCPv6.
- Manual—Manually specify up to two IPv6 DNS name servers in the fields
provided.
STEP 3 Configure an IPv6 tunnel using ISATAP.