Administration
System Settings
Cisco WAP131 and WAP351 Administration Guide 36
3
System Settings
Use the System Settings page to configure information that identifies the WAP
device within the network.
To configure system settings:
STEP 1 Select Administration > System Settings.
STEP 2 Configure these parameters:
• Host Name—Enter the host name for the WAP device. By default, the name
is the fully qualified domain name (FQDN) of the node. The default host name
is wap concatenated with the last 6 hexidecimal digits of the MAC address
of the WAP device. The host name label can contain only letters, digits, and
hyphens. It cannot begin or end with a hyphen. No other symbols,
punctuation characters, or blank spaces are permitted. The host name can
be 1 to 63 characters long.
• System Contact—Enter the contact person for the WAP device. The system
contact can be 0 to 255 characters long and can include spaces and special
characters.
• System Location—Enter the physical location of the WAP device. The
system location can be 0 to 255 characters long and can include spaces and
special characters.
STEP 3 Click Save. The changes are saved to the Startup Configuration.
User Accounts
One management user is configured on the WAP device by default:
• User Name: cisco
• Password: cisco
Use the User Accounts page to configure up to four additional users and to change
a user password.
To Next Page
Loading...
