4
Cisco WAP131 and WAP351 Administration Guide 65
LAN
This chapter describes how to configure the port, VLAN, IPv4, and IPv6 settings of
the WAP device. It includes these topics:
• Port Settings
• VLAN Configuration
• IPv4 Setting
• IPv6 Setting
Port Settings
Use the Port Settings page to view and configure the settings for the port that
physically connects the WAP device to a local area network.
Configuring Port Settings for Cisco WAP131
To configure the port settings:
STEP 1 Select LAN > Port Settings.
The Operational Status area shows the type of the port used for the LAN port and
the link characteristics, as configured in the Administrative Settings area. If the
settings change through configuration or autonegotiation, you can click Refresh to
show the latest settings.
STEP 2 Enable or disable Auto Negotiation.
• When enabled, the port negotiates with its link partner to set the fastest link
speed and duplex mode available.
• When disabled, you can manually configure the port speed and duplex
mode.
To Next Page
Loading...
